carbon covered calibra

[ryan_warman]

what would people think or a calibra covered in carbon fibre vinly?

[v6 steve]

if it was matt black it would look well moody

[ryan_warman]

it looks matt black ish from far but close up you can see the weave i might give it ago n be different as it will be cheaper than spraying the car

[ryan_warman]

i might only as im trying to save for a new car and 700 quid getting sprayed compared to the 50 quid the vinly will cost i would rather have the 650 in the car pot

[v6 steve]

£700 for a respray ? thats cheap but £50 to wrap a car i was twice that just to do some dash board parts 2 years ago, good luck

[matty0785]

if vinly is only 50 quid it wont be upto much and poor quality if your going to do it do the job right look into 3m di-noc its about 50 quid a metre

[RobbieV]

if vinly is only 50 quid it wont be upto much and poor quality if your going to do it do the job right look into 3m di-noc its about 50 quid a metre

You can find 3m di-noc vinyl cheaper then that on ebay.

[moddedcalibra]

If I had a air horn I would be blowing it and screaming no right now. Please don't vinyl wrap the car. As amazing as the idea sounds its not. I had mine done by a professional Company that used 3m vinyl and they F****d it right up. It was fully wrapped for 2 weeks in total before I ripped the whole lot off. The straight panels were ok but they just couldn't do the bumpers as there were to many curves. Understandable I mean look at the front grill for instance. Looks a right f****r to wrap. If u wrap it u will regret it. Check out my link. Pics are on website under wrapping.


www.jamespdunn.co.uk/wp/Calibra-project

[Phil69]

Found this although I cant say for sure if its real carbon or vinyl:

[poita]

that one is real carbon fibre.

[v6 steve]

that looks cool as Phil but i hear what you saying moddedcalibra if its not done 100% right it will look s**t